Seals

Vestil Dock Seals

  • Combines the advantage of low cost and excellent sealing action
  • Designed for maximum energy savings with long-lasting features

For use with an 8′W x 8′H (D-150-XX) or 8′W x 9′H (D-350-XX) door.

  • Superior 36 oz. nylon reinforced vinyl facing has a higher tear strength than equivalent weight hypalon.
  • Chemically sealed ends prevent moisture infiltration.
  • Full height air escape tunnel.
  • Mounted and bonded on durable wolmanized wood.
  • 2″ nylon reinforced guide stripes.
  • Through the wall installation kits included.

Three piece construction: top – 12″ high; sides – beveled sides with 9 1⁄2″ width at the wall and 12″ width at the face. 5″ maximum compression is recommended. Applications with a flush dock to building in conjunction with an Edge-O-Dock use a 20″ projection Dock Seal. To ensure proper size, complete and email or fax the survey sheet. Units are non-returnable.

Dock Seal/Shelter Combinations

  • For use with an 8′W x 10′H door.
  • Top (header) is constructed of wolmanized lumber and is built with a slope to allow for water run-off.
  • Header measures 114″W with a 30″ drop curtain.
  • Side (verticals) measure 120″ tall and contain high density foam mounted to treated lumber.

Once mounted, the face of the vertical will measure 12″W and will taper to 91⁄2″ at wall. Verticals are mounted on wooden 2″ x 12″ to allowing wall mounting down the length of the vertical pieces. Applications with a flush dock to building in conjunction with an Edge-O-Dock use a 20″ projection Dock Seal. To ensure proper size, complete and email or fax the survey sheet. Units are non-returnable.

Dock Shelters

  • For use with doors up to 10′W x 10′H.
  • Reduces oversized doors to match truck opening.
  • Long wear Vestex V-42 fabric is highly resistant to abrasion and tearing.
  • Fiberglass staves are sewn into the flaps.

Seal is formed along the sides and top of trailer when the vertical and top panels are pushed inward by the trailer. Recommend minimum 10″ trailer penetration for a good seal. Supporting structure is made of 2 x 4 wolmanized lumber. Shelter is protected by safety yellow steel guide protectors.

The top header piece measures 132″W and contains a drop curtain which measures 36″H. Two vertical pieces measure 126″ tall with vertical flaps measuring 21″W. When installed the shelter will close door opening down to 90″W x 90″H opening (between flaps). Includes two yellow steel guide protectors and foam-filled corner pads for extra sealing action.

Retractable Dock Shelter

The Retractable Dock Shelter fits up to a 120″W x 120″H door. Independent spring loaded scissors mechanism allows shelter to retract with the trailer keeping the shelter square. The design also eliminates the need for rigid steel guide protectors.

  • Overall size 132″W x 126″H x 24″ projection.
  • The 40 ounce reinforced vinyl flaps close the opening down to 90″ x 90″.
  • The 36″ header curtain has armor pleats for extended wear.
  • Shelter is black with aluminum edge trim.